| Railway Preservation News https://rypn.org/forums/ |
|
| Norton jacks
https://rypn.org/forums/viewtopic.php?f=1&t=778 |
Page 1 of 1 |
| Author: | Dave [ Wed Sep 15, 1999 11:52 pm ] |
| Post subject: | Norton jacks |
Out of a pallett full of old A N Norton and Duff Norton car jacks, about 1.5 work. These jacks are the ones with an external ratchet and large internal screw. The common problem is the outside casting turns rather than raises and lowers. The mechanisms are also very stiff. <p>My gut reaction is that the screws are probably full of grunge, but how to get into them is a mystery - anybody out there have any experience with these things? Should I just go back to track jacks and hydraulics?<p>Dave<br> lathro19@idt.net |
|
| Author: | Don [ Fri Sep 17, 1999 10:31 am ] |
| Post subject: | Re: Norton jacks |
It has been a while - but I seem to remember that the bottom of the jack unscrews to get at the works.There is a lock screw in the side of the body to retain the screwed cover. Ours were really painted over and generally difficult to remove. I do not know if all Duff-Nortons are this construction<br> donmicheletti@cs.com |
|
| Author: | Dave [ Sat Sep 18, 1999 8:56 am ] |
| Post subject: | Re: Norton jacks |
Thanks to Harry and Don and those who responded off list. Turns out Duff Norton is in Charlotte of all places so i can get peprsonal attention in my home town. <p>Dave<br> lathro19@idt.net |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|