Railway Preservation News
http://rypn.org/forums/

Pressure Gauges and calibration
http://rypn.org/forums/viewtopic.php?f=1&t=42574
Page 1 of 1

Author:  mrwalsh85 [ Wed Oct 10, 2018 1:09 pm ]
Post subject:  Pressure Gauges and calibration

Hello,

I have recently acquired a pressure gauge, that I find to be pretty neat.

Unfortunately the needle is at 280 psi (0-300 psi gauge) and I'd like to get it fixed up so that it can be put to use.

I used to have a dead weight tester, but sold it - go figure.

Does anyone have any suggestions or referrals for such services? I'm not in terribly big of a hurry but it'd be nice to get this sent off and know that it's good to go for the next application I'd like to place it on.

Thanks in advance,
Mike Walsh

Author:  CCDW [ Wed Oct 10, 2018 1:59 pm ]
Post subject:  Re: Pressure Gauges and calibration

Try:

Gauge Repair Service
365 Van Ness Way #507, Torrance, CA 90501
Phone 310.212.0912 | Fax 310.320.3032

They have always done well by us and they work on older gauges.

CCdW

Author:  Steve DeGaetano [ Wed Oct 10, 2018 3:34 pm ]
Post subject:  Re: Pressure Gauges and calibration

If you're on the East coast, we've used Certified Valve Repair in New Jersey for our gauges and safety valves:

http://www.certifiedvalve.com/index.html

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/